Day 3

Introduction to Zbrush Digital Tutors

Setting up reference images

– These steps are specific to this model:

– draw a cylinder primitive

-in the Initialize palette set X and Y size to 20

– in the Deformation palette rotate by 90 degrees in the X axis

– subdivide several time

– Make PolyMesh3D

Preparing the start of the model.

– under the Draw Menu there is a palette specifically for grids and reference maps. Options include which faces to assign Maps to (Front-Back, Left-Right, Up-Down), and an option for using one Map for both planes (one).

buttons for assigning reference images to different planes around the model.

– Map1 / Map2 brings up the texture palette to select an image.

– If the image you wish to use isn’t in the texture palette, go to Texture > Import and the images will be available next time you click on Map1 / Map2. Other options are enabled once a Map is loaded.

Once an image is imported it can be applied to any of the reference map buttons.

– Draw > Snap > Snap to Mesh snaps the reference map to the size of the mesh on the canvas.

Snap to Mesh makes the reference image the size of the mesh on the canvas.

– Draw > (F-B/U-D/L-R) > Adjust allows for changing the reference map’s colour, contrast and cropping.

reference maps can be cropped and adjusted within Zbrush.

– To make the reference map visible through the mesh use Draw > Fill Mode 1 / 2 / 3, or the Front button.

Use the fill mode slider to change how visible the reference map is during sculpting.

– once reference maps have been set they can be all switched off at the same time using the floor button on the right shelf.

– Reference images can be created from a model using Draw > Snapshot to Grid, which creates a texture map for each of the six planes.

Use the Snapshot to Grid button to create reference images from a 3D model.